MODBUS PD25B five way 0-10V dimming module - five channel independent control/WiFi+HomeKit+Modbus the third mock examination

freeFree Technical Resource

This content is free to read, suitable for basic learning and search traffic.

MODBUS PD25B five way 0-10V dimming module - five channel independent control/WiFi+HomeKit+Modbus the third mock examination缩略图

Product Overview

MODBUS PD25Bis a professional dimming and speed regulation module with five independent 0-10V analog signal outputs. Each channel is independently controlled and can simultaneously drive five 0-10V LED dimming drivers or five 0-10V fan speed controllers. Supports RS485 bus (Modbus RTU), WiFi wireless, and Apple HomeKit control methods, suitable for commercial lighting, exhibition hall lighting, plant factories, and other scenarios that require multi-channel independent dimming.The professional dimming and speed regulation module, each independently controlled, can simultaneously drive 5 channels of 0-10V LED dimming drivers or 5 sets of 0-10V fan speed regulators. Supports RS485 bus (Modbus RTU), WiFi wireless, and Apple HomeKit control methods, suitable for commercial lighting, exhibition hall lighting, plant factories, and other scenarios that require multi-channel independent dimming.

Five channel independent control

  • Channel 1-5 independent dimming: Each channel outputs 0-10V independently and can be adjusted from 0-100% without affecting each other
  • Batch control: Supports multi-channel simultaneous setting to the same or different values
  • Dimming curve: Supports linear and logarithmic (human perception) dimming curves

Control Mode Comparison

ModeProtocolDelayApplicable
RS485 BusModbus RTU<10msCentral Control System Integration
WiFiHTTP/TCP<50msAPP/HA Direct Connection
HomeKitHAP<100msApple Home/Siri

Modbus Register Mapping

The brightness values of channels 1-5 are mapped to hold registers 0x0000-0x0004, with a range of 0x0000-0x00FF (0-255 corresponds to 0-100%). Support function codes 03 (read) and 06/10 (write).

Installation and wiring

  • DIN rail installation, optional back card for cabinet installation
  • Power supply DC 12-24V
  • 5 channels of 0-10V output terminals (Vout+, GND for each channel)
  • RS485 A/B terminals
  • Suggest using shielded twisted pair cables for 0-10V signal lines, with a length not exceeding 50 meters

🛒 Purchase and Consultation

The MODBUS products introduced in this article can be purchased through official channels.

📍 Modbas Intelligence|12th Floor, Tower A, Langqing Plaza, Guanyin Bridge, Jiangbei, Chongqing, China
📞 Phone:+86-023-65218879 | Duty phone:+86-17723047591
📧 Email: admin@modbus.com | 🌐 Official website:www.modbus.cn
📱 WeChat Mini Program Search"Modbus Debugging Assistant"for more product information

Put this resource to use in a real project?

Go to the Tool Center for message parsing, CRC verification and device debugging, or submit your requirements for selection and integration advice.

Engineer Membership

Turn this article into actionable debugging resources

After activation, you can use advanced message parsing, resource pack downloads, code examples, engineering cases and priority technical support, suitable for real project delivery.

Unlimited Advanced Tools
Resource & Code Packs
Complete Engineering Case Library
Priority Technical Support

Leave a Reply

Your email address will not be published. Required fields are marked *.