(1) Flap Barrier
1) Control Mode: Network Mode, RS232, RS485, I/O
2) Network Interface: 1, 100M Ethernet Port
3) Serial Interface: 2, Standard RS-232 Serial Interface, 1 Standard RS-485 Serial Interface
4) USB Interface: 1 USB3.0, 1 miniUSB3.0
5) I/O: 8 Input Ports; 8 Output Ports
6) Mean Time Between Failures (MTBF) > 2,000,000 Times
7) Average Lifespan > 5,000,000 Times
8) Detection Pairs: 12 Pairs
9) Passage Frequency: 20--60 People/Minute
10) Power Supply: 220VAC 50/60Hz
11) Power Consumption: Operating Power < 150W; Standby Power < 20W
12) Operating temperature: -20℃--＋60℃
13) Operating humidity: 5%--90% without condensation
14) Channel width: 550mm--900mm
15) Door wing material: 10mm plexiglass / 8mm tempered glass (optional)
16) Channel frame: GB 2.0mm thickness + 304 stainless steel brushed finish
(2) Automatic barrier gate
1) Input power: 220V 50Hz
2) Motor power: AC servo motor adopted
3) Operating speed: 3-4 seconds
4) Bar length: Determined according to site conditions
5) Bar gate direction: Right/left direction selectable
6) Bar gate type: Straight/curved bar, determined according to site conditions
7) Thermal protection: The motor is equipped with overheat protection to prevent abnormal damage to the barrier.
8) Automatic pole lowering: It features the function of automatically lowering the pole when there is no vehicle for a long time;
9) Manual lifting and lowering function: In case of power failure, it allows for quick disengagement and manual lifting and lowering of the pole.
10) Operating environment: All-weather conditions indoors and outdoors.
11) Operating voltage: AC220V±10%;
(3) Access control machine
1) Operating system: Embedded Linux operating system;
2) Interfaces: ≥2 video output interfaces, ≥1 RJ45 interface, ≥1 RS-485 interface, ≥1 RS-232 interface, ≥1 VGA interface, ≥1 SATA interface, ≥1 vehicle coil input interface, ≥1 USB2.0 interface, ≥1 switch input, ≥2 switch outputs, and ≥1 switch output for vehicle detector;
3) Device access: It supports the access of pedestrian face capture devices and long-distance card readers. It also supports the access of IP cameras and network capture devices, and transmits video images from IP cameras to the client via the network. It can support up to 4 IP cameras, allowing simultaneous access of high-definition video and images;
4) Card storage capacity: 350 cards
5) Video management: It has a built-in 1G solid-state drive for storing vehicle passing data and other information;
6) Control release method: Automatic release based on license plate, automatic release based on card, consistency between vehicle and card, and single-in and single-out release;
7) Blacklist Check: Vehicles identified as blacklisted will not be automatically allowed to pass. Records of passing vehicles that match the blacklist criteria will be marked and uploaded remotely to the client.
8) Real-time Video Preview: Video images from each channel can be previewed through WEB, VGA, or client software.
9) Voice Intercom: Remote voice intercom is available.
10) Multi-channel Matching: Multiple cameras can be simultaneously connected to capture and identify vehicles from multiple angles, outputting high-definition results for upload.
11) Operating Temperature: -25°C to 75°C, humidity 10% to 95% (no condensation)
12) Communication Method: Network communication
13) Display: LED Chinese electronic display screen, four-character monochrome screen. The display screen for both Chinese and English information is installed directly above the control unit, showing parking time, toll amount, card balance, card expiration date, etc. If the system denies entry or exit, it will display the relevant reason in a clear and intuitive manner.
(4) Vehicle Detector
1) Supported coil channel count: 2
2) Automatic tuning inductance range: 20μH to 1000μH, Q value ≥5.
3) Vehicle detection rate ≥99%.
4) Sensitivity (-△L/L): 0.02% to 0.96%, adjustable in 8 levels (0 to 7).
5) Coil operating frequency: 28~120KHz, with 4 levels configurable (highest, high, low, lowest).
6) Presence time: 6 levels configurable (invalid, 30 seconds, 2 minutes, 5 minutes, 10 minutes, 30 minutes).
7) Maximum response time: 46±1.4ms.
8) Coil fault recovery time ≤100ms.
9) Coil fault detection cycle: 30 seconds.
10) Output port: relay switch output, maximum withstand current 1A, maximum supported voltage 110V AC, 24V DC.
11) Power supply: DC9-12V.
12) Power consumption: ≤3W.
13) Operating ambient temperature: -30℃ to +80℃.
14) Operating ambient humidity: <90%, no condensation.
(5) Vehicle entrance and exit video integrator.
1) Sensor type: 1/3 inch 2 million pixel color progressive scanning high-definition intelligent camera;
2) Resolution: 1920 (W) × 1200 (H)
3) Parameter Configuration: Exposure speed, AGC control, white balance control, etc.
4) Video Encoding: H.264
5) Image Format: JPEG
6) Interface Requirements: RJ45 ≥ 1 port, RS-485 interface ≥ 1 port, RS-232 interface ≥ 1 port, fill light control interface ≥ 2 ports, switch input ≥ 2 ports, alarm input ≥ 2 ports, alarm output ≥ 2 ports, audio input ≥ 1 port, audio output ≥ 1 port, SD card slot ≥ 1 port
7) Fill Light Control: Built-in LED fill light
8) Blacklist and Whitelist Function: Capable of storing blacklist and whitelist and automatically controlling the opening/closing of the barrier gate
9) Trigger Mode: Compatible with both coil trigger and video trigger;
10) Terminal Access: Supports terminal access.
11) Operating Temperature: -30℃ to 70℃, humidity less than 90% (no condensation)
12) Operating Voltage: AC100V to 240V ± 10%
(6) Special Functions
1) Supports simultaneous preview of 4-channel videos;
2) Supports local monitoring video image preview;
3) Supports automatic boom lifting and release for internal vehicles and VIP vehicles;
4) Supports deployment and alarming for blacklisted vehicles and special vehicles;
5) Supports various methods such as software prompts, audible and visual alarms, or LED displays;
6) Supports remote download and update or external import of internal vehicle databases and deployment vehicle databases;
7) Supports local data query, backup, and maintenance;
Leave a Reply